This Trystar TATS-02 Automatic Transfer Switch combines a three-phase 200A automatic transfer switch with camlock connections in one simple enclosure. UL1008 Listed.
FEATURES
- Cost-effective and space-saving, combining two typically separate cabinets into one.
- 200A, 3-Phase, 3-Pole, 4-Wire, Solid Neutral, Open Transition automatic transfer switch.
- ABB TrueOne Level 4 Controller with touch screen HMI.
- Manual operation capability of the ATS.
- Silver-plated copper busbar with mechanical lug terminations for permanent source connections and load connections.
- Male 16 Series camlock panel mounts to connect to a mobile generator.
- Protective caps on all panel mounts to prevent accidental contact.
- Phase rotation monitor.
- Aluminum NEMA 3R outdoor enclosure.
- Padlockable swinging front door.
- Trystar rake theft reduction system.
- Tabs on back for wall-mounting.
- ETL Listed to UL 1008 Standards.
- UL 50 Listed enclosure.
Please Note: Load Bank Connections, Load Shed Receptacle, Service-Rated Disconnect, and Two-Wire Auto Start are options, and must be ordered with the ATS if desired. See below for a list of available options.
DOWNLOADS
ABB TruOne Controller Features
OPTIONS
- A: Two-wire auto start.
- B: Battery charger receptacle – 20A 125V Duplex.
- C: Battery charger receptacle – 20A 125V GFCI.
- D: Block heater receptacle – 30A 125V L5-30.
- F: 50A 125/250V Twistlock.
- G: 100% Grounded.
- H: SCADA terminal port.
- I: Stainless steel construction.
- J: Extra depth for bottom conduit access.
- K#: Kirk key door interlock.
- L: Custom Lug Size or Compression Type.
- M: Listed Monitoring Device.
- N: Strip heater with thermostat.
- O: Custom Listed Receptacles.
- P: Surge Protection Device.
- Q: Load dump receptacle.
- R: Service Entrance Rated.
- S: Special request.
- W: 4-Pole Switched Neutral.
- Leg kit.
- Load bank connections for a permanent generator.
- Single breaker on utility, generator, or load side.
- Other three phase voltages.
Reviews
There are no reviews yet.