Trystar TATS-10 SER Automatic Transfer Switch (1Ph, 1000A)

This Trystar TATS-10 SER Automatic Transfer Switch combines a single-phase 120/240V 1000A automatic transfer switch with camlock connections in one simple enclosure. Includes Option R: Service Entrance Rated. UL1008 Listed.

FEATURES

• Cost-effective and space-saving, combining two typically separate cabinets into one.
• 1000A, 1-Phase, 2-Pole, 3-Wire, Solid Neutral, Open Transition automatic transfer switch.
• Includes a breaker on the utility side of the transfer switch for Service Entrance Rating.
• ABB TrueOne Level 4 Controller with touch screen HMI.
• Manual operation capability of the ATS.
• Silver-plated copper busbar with mechanical lug terminations for permanent source connections and load connections.
• Male 16 Series camlock panel mounts to connect to a mobile generator.
• Protective caps on all panel mounts to prevent accidental contact.
• Phase rotation monitor.
• Aluminum NEMA 3R outdoor enclosure.
• Padlockable swinging front door.
• Trystar rake theft reduction system.
• Tabs on back for wall-mounting.
• ETL Listed to UL 1008 Standards.
• UL 50 Listed enclosure.

Please Note: Load Bank Connections, Load Shed Receptacle, and Two-Wire Auto Start are options, and must be ordered with the ATS if desired. See below for a list of available options.

DOWNLOADS

TATS Spec Sheet

ABB TruOne Controller Features

Part Number Matrix

OPTIONS

• A: Two-wire auto start.
• B: Battery charger receptacle – 20A 125V Duplex.
• C: Battery charger receptacle – 20A 125V GFCI.
• D: Block heater receptacle – 30A 125V L5-30.
• F: 50A 125/250V Twistlock.
• G: 100% Grounded.
• H: SCADA terminal port.
• I: Stainless steel construction.
• J: Extra depth for bottom conduit access.
• K#: Kirk key door interlock.
• L: Custom Lug Size or Compression Type.
• M: Listed Monitoring Device.
• N: Strip heater with thermostat.
• O: Custom Listed Receptacles.
• P: Surge Protection Device.
• Q: Load dump receptacle.
• R: Service Entrance Rated.
• S: Special request.
• W: 4-Pole Switched Neutral.
• Leg kit.
• Load bank connections for a permanent generator.
• Single breaker on utility, generator, or load side.
• Other three phase voltages.